Leave Your Message

ANZSE10(F) / ANISE10 Series Slim Digital Pressure Switch

・Converts air pressure into a proportional electrical signal for real-time monitoring and control

・Ultra-Slim & Lightweight Design: Only 9.8 mm thickness, enabling compact and space-saving installation

・Suitable for vacuum, compound, and positive pressure applications

・Fast Response with Anti-Chatter Function: Response time: ≤ 2.5 ms

・Adjustable response delay (20 / 100 / 500 / 1000 / 2000 ms) to prevent output fluctuation caused by pressure vibration

    Product Overview

    ANZSE10(F) / ANISE10 Series Slim Digital Pressure Switch for Pneumatic Systems.

    The ANZSE10(F) / ANISE10 series is a compact, high-precision digital pressure switch designed for continuous pressure monitoring and control in pneumatic automation systems.

    With an ultra-slim 9.8 mm profile, clear digital display, and fast response, it delivers reliable performance while saving valuable installation space.

    Application Spotlight

    ・Pneumatic automation systems

    ・Assembly and packaging machines

    ・Vacuum and air pressure monitoring

    ・Industrial control panels

    ・Compact equipment with limited mounting space

    Technical Parameters

    Model Number ANZSE10
    (vacuum pressure)
    ANZSE10F
    (Mixed pressure)
    ANISE10
    (Positive pressure)
    Rated Pressure Range 0.0~-101.0kPa -100.0~100.0kPa -100.0~1.000MPa
    Set Pressure Range/Display Pressure Range 10.0~-105.0kPa -105.0~105.0kPa -105.0~1.050MPa
    Test Pressure 500kPa 500kPa 1.5MPa
    Minimum Setting Unit 0.1kPa 0.1kPa 0.001MPa
    Suitable Fluid Air·Non-corrosive gases·Non-flammable gases
    Power Supply Voltage DC12~24V±10%、Fluctuation(p-p)
    Below 10%(With reverse connection protection)
    Current Consumption Below 40mA
    Switch output NPN or PNP open collector 2-output (selectable)
    Maximum load current 80mA
    Maximum applied voltage 28V(When NPN is output)
    Residual voltage Below 2V (when the load current is 80mA)
    Response time Less than 2.5ms (for anti-oscillation function: select from 20, 100, 500, 1000, 2000ms)
    Short circuit protection Equipment
    Repeatability ±0.2%F.S. ±1digit
    Hysteresis Hysteresis mode It can be changed starting from 0 (Note)
    Upper and lower limit comparison mode
    Analog output Voltage output Output voltage
     (rated pressure range)
    1~5V±2.5%F.S. 0.6~5V±2.5%F.S.
    Linearity ±1% F.S. below
    Output impedance Approximately 1kΩ
    Display method 31/2-digit 7-segment LEDs   1-color display as follows
    Display precision ±2%F.S. ±1digit(At an ambient temperature of 25±3℃)
    Action indicator light When the switch is ON, the lights illuminate: OUT1: Green, OUT2: Red.
    Environmental resistance Protection rating IP40
    Operating temperature range Operating temperature: -5~50℃; Storage temperature: -10~60℃ (without condensation or freezing).
    Operating humidity range During the action·When saving:35~85%RH(no condensation)
    Withstand voltage AC1000V 1 minute between charging unit and casing
    Insulation resistance 50MΩ or higher (DC 500V megohmmeter) Between the charging section and the housing
    Vibration resistance 10~150Hz, full amplitude of 1.5mm or 20m/s² (the smaller), for 2 hours in all x, y, and z directions (without power).
    Shock resistance 100m/s² XYZ 3 circuits in each direction (without power)
    Temperature characteristics ±2%F.S. (Applicable temperature range: -5~50℃, 25℃ as the baseline)
    Wire Oil-resistant ethylene rubber insulated cable
    5-core  Conductor cross-sectional area: 0.15mm² (AWG26)   Insulator outer diameter: 1.0mm
    Specifications CE marking  UL (CSA) RoHS Compliance
    Note: When the applied pressure varies around the set value, oscillations will occur if the hysteresis is not set above the range of variation.

    Piping Specifications

    Model M5 M5
    Pipe caliber M5×0.8
    (Side piping)
    M5×0.8
    (Rear piping)
    Contact fluid part
    Material
    Sensor pressure-bearing section Sensor pressure-bearing part: silicon
    Piping port C3604 (electrolytic nickel plating)
    O-rings: HNBR
    Quality Includes 5-core, 2m wire with plug 55g
    Excludes wire with plug 15g

    ANZSE10f-ANISE10 slim digital pressure switch External dimensions-1ANZSE10f-ANISE10 slim digital pressure switch External dimensions-2

          FAQ

        • Which model should I choose for my application?

        • Is this pressure switch suitable for compact or space-limited equipment?

          Yes. With a 9.8 mm ultra-slim profile, this series is specifically designed for compact installations, dense control panels, and small pneumatic assemblies.
          👉 Send us your installation layout or space requirements for confirmation.